Standard format change-engineering

→ **MyCalcs** profile · by **jmat** » 06 Aug 2013, 01:37

hello, someone would be so kind as to help me make a program change format to engineering a data standard and backwards, as in the FX570 with the key casio ENG

thanks

→ **MyCalcs** profile · by **Bisam** » 06 Aug 2013, 23:53

You don't need a program for that. Just use the settings...

→ **MyCalcs** profile · by **jmat** » 08 Aug 2013, 23:43

would you be so kind as to show me a tns file? thanks

My calculator programs · by **Adriweb** » 08 Aug 2013, 23:44

There is no .tns File. As said, use the Setting in your calculators.
Look in the manual to change the mode

→ **MyCalcs** profile · by **jmat** » 08 Aug 2013, 23:48

if, so if you do, I would like to live together on a single sheet 2 formats.

→ **MyCalcs** profile · by **Bisam** » 09 Aug 2013, 23:44

You will have to use a program if you need both formats.
You can use the function "format" for this.
See the manual for more information.

→ **MyCalcs** profile · by **jmat** » 10 Aug 2013, 02:45

I'm new to the Nspire, I've been looking at the manual but do not know how, could you help me? thanks

→ **MyCalcs** profile · by **jmat** » 10 Aug 2013, 11:51

Code: Select all: Define LibPub formato(n1)= Prgm Local s1 ,n1 n1→n1 If setMode(3,1) = n1 Then n1▶setMode(3,3)→s1 Disp "formato ingenieril: " ,s1 EndIf If setMode(3,3) = n1 Then n1▶setMode(3,1)→s1 Disp "formato normal: " ,s1 EndIf EndPrgm

Mes programmes · by **Levak** » 10 Aug 2013, 12:03

Remove or change "n1" from "Local s1, n1", you're overriding n1's definition.

→ **MyCalcs** profile · by **jmat** » 10 Aug 2013, 14:28

Code: Select all: Define LibPub formato(num)= Prgm Local num2 num→num2 If setMode(3,1)=num2 Then num2▶setMode(3,3) EndIf If setMode(3,3)=num2 Then num2▶setMode(3,1) EndIf EndPrgm

could assert so?