Forum TI-Planet.org

Hello friends,

I install the Tictexpv in my V200 and when i´m going to run it, appears the message "Address Error"

I already reset the calculater and install again but the problem continues...

Can you help me?

Thanks

Try sending the OS from your computer to your calc.
Your calc should get back a normal state.

If you think this program (Tictexpv) is the origin of the problem... just don't use it again.
I don't know it, so I can't help you about it !

I already Install the most recent OS...

Then install again the Tictexpv, but did´t run and it always run so far...

The problem is that this program is very usefull for me to send documents to calculater..


Thanks for reply me

Which calc do you have ? (You should update your profile...)

It may need to be a little tweaked to accept running some Assembly programs as this one.

You could for example install PreOS (even if you don't need it).
At first installation, it will do the necessary tweaks and you won't be bothered anymore with that.
It will also prevent some crashes, once installed...

But you can uninstall right after installng it if you please.

Sorry, I´m updating now...

I have a Voyage 200.

What is PreOS?

PreOS is a so-called "kernel". It's used by some assembly programs which need such a program.
You can find it by using the "search" field...

So you sugest me to install "Kernel" and then install the programs?

TICTEXPV doesn't need you to install a shell/kernel.

But you can still try.

I Tried but still doesn´t work...

@Bisam: tictexpv is the main program for reading files generated by mViewer GX Creator 68k
PreOS is useless for tictexpv (or any other TICT program, in fact).

@bruno costa: does the Address Error occur even if the calculator contains no files suitable for tictexpv ?

No Address Error occurred for me before releasing the new build, otherwise it wouldn't have been released.