Downgrade ta CX non-CAS de 3.9.1 à 3.6 pour Ndless 3.6

[Adriweb]

And if you go back to 3.9.1, does it get back to working normally ?

I don't think we have even seen such a problem, it's quite weird...

[Levak]

Nothing's working.

If the calc turns off in the Diagnostic Sofware when you unplug the USB cable, then it has nothing to do with Ndless. You may have a battery or connector problem. Make sure it has some battery power first.

[Thatguy]

The battery is at 100%.

[Thatguy]

The calculator works when I switch the firmware back to 3.9.1 but the thing is I would like to use ndless. I didn't install it when I had the problem. I think there is something wrong with the 3.6 os file itself.

[the99o]

i have the same problem. have you been able to fix it?

[critor]

The calculator works when I switch the firmware back to 3.9.1 but the thing is I would like to use ndless. I didn't install it when I had the problem. I think there is something wrong with the 3.6 os file itself.

The hosted 3.6 files are perfectly ok as they did work with many other users.

You didn't accurately answer our questions, so it's hard to help you.

[the99o]

my battery power is at 100%. it is not a connector problem as it works normally with another os. it only works as long as its plugged in to a power source (pc or charging cable).

[critor]

I don't understand what you mean by "it works".
Be more accurate please.

[the99o]

when in 3.9.1 the calculator works completely normal like it should.
when in 3.6 the calculator starts, loads and after the little clock symbol was there it turns itself off.
that does not happen when the calculator is plugged into any kind of power source.
i already tried installing 3.6 again.
is it normal that my boot 2 is still 3.9.1.34?

[critor]

Thank you very much.

Once the calculator is off after booting OS 3.6, can you turn it back on ?


Boot2 3.9.1.34 shouldn't be a problem.